SPANISH MAUSER SCOPE MOUNT HOW TO

Now using your level again, make sure the rifle is level side-to-side and then use the level on the upper turret ring to level your reticule.All Steel LSR Sniper Scope Mount for German Mauser, K98 98K K98K All Steel LSR Sniper Scope Mount for German Mauser, K98 98K K98KĪll steel LSR Sniper scope mount for German Mauser K98. Mount your scope loosely and adjust the eye relief. I used a silver Sharpie marker to do this. If you ever have to remount a scope this will help. When you’ve done this, remove the upper part of the rings and mark them as to which ring they are and their orientation. Once that is done, figure out where you want the rings, Put them in the appropriate slots and tighten up the lower half.

Then back one out, coat it with Loc-tite and reinstall, then, do the other one. You may have to switch them as they are different lengths to get them to seat properly. Treat them like a teeter totter until it is level. Once you’re level use the level on the scope base to get it level also. If the magazine follower is in the way, drop the magazine plate and follower. Once that’s done, use a small spirit level across the flats of the receiver to get the rifle level. If that happens, use the original pin ( that’s why it’s important to treat it gently!). If you are as lucky as I generally am, it won’t fit. Once the mount fits, use the roll pin supplied by B Square and drive it in carefully. My gunsmith says people like me are why rotary tools should have to be licensed, so go slowly ( as you can’t put metal back once it’s gone) and test fit constantly until it fits snugly. You may have to take a rotary tool or file to the mount, not the sight base to get it to fit. The sight ears were too tight to allow a drop in installation. You may also have to remove the hand guard to get the spring out. I had to deepen the groove slightly to get it free. Next, remove the screw holding the spring in. Then lift up on the rear sight a little and just push down and pull back and it should slide right out. Be careful with this part as you may need it later. Using a pin punch drive the rear sight retaining pin out of its place. Here’s the step by step instructions for mounting the mount and scope ….įirst, make sure the rifle is unloaded. This is just one of many methods to determine your dominant eye.Ĭopyright, International Hunter Education Association, Inc. Your finger will remain lined up with the object when your dominant eye is open. To find out which is your dominant eye, point your finger at a distant object with both eyes open. Being cross-dominant ( right-handed, but left-eye dominant), I wanted to mount a scout scope on it to get all the accuracy out of it I could. The price was right, the bore was pristine and the little beast went home with me. Corey at Strictly Outdoors in Harrisburg, IL called and told me he had just got one. I had been looking for one of these little beauties for a while ( ever since a friend talked me out of my Israeli 98 in. Blue finish.įirst before starting any firearm related project: Make sure the rifle is unloaded and pointed in a safe direction.

Elevation adjustment so any LER (pistol) scope can be used without a change in zero. Remove rear sight leaf Mount to rear sight base Use Long Eye Relief (LER) Scope. One piece sight mount & 1' rings packaged together. Manufacturer Product Description and Price

SPANISH MAUSER SCOPE MOUNT HOW TO

How to mount a B Square Scout mount on a Mauser 1916 ( or enjoy a couple of hours in the garage).

Spanish mauser scope mount